Sort by:
DB9 Female Screw Terminal to RS232 RS485 Conversion Board (1pcs)
This is a DB9 Female Screw Terminal to RS232 RS485 Conversion Board module, RS232 Serial DB9 9-pin to 9 Position Screw Terminal Block. Connector DB9 adapter terminals to facilitate commissioning...
I2C Bi-Directional logic Level Converter- 4 Channel
This I2C Bi-Directional logic Level Converter- 4 Channel features four high speed bi-directional 4 channels, allowing for safe and easy communication between devices operating at different logic levels. The logic...
CH376S USB Module U Disk Read Write Module Interface Communication 8-bit - CH375B
CH376S is used as a file manage control chip, used to MCU system read/write a file in USB Flash Drive or SD card. It supports USB-Device Mode and USB-HOST Mode....
PCF8574T I2C I/O Extension Board
The PCF8574 IO Expansion Board is used as remote 8-bit I/O expander for I2C-bus. Up to 8 PCF8574, IO Expansion Board can be connected to the I2C-bus, providing up to 64 I/O ports. The PCF8574...
USB to Serial RS232 TTL UART Converter Module Adapter - CP2102 based
Download Drivers from http://www.silabs.com/products/mcu/pages/usbtouartbridgevcpdrivers.aspx (No Driver CD included)RS232 with DB9 connector + TTL points on board - USB specification 2.0 compliant with full-speed 12Mbps.CP2102 Based - Better and Faster than...
PCF8591 AD / DA Conversion of Analog to Digital /Digital-to-Analog Converter Module Temperature Illumination
This is a breakout board/Prototype Board for PCF8591 IC. The PCF8591 Module Analog to Digital / Digital-Analog Converter Module with F-F Jumper Wire is a single-chip, single‑supply low‑power 8‑bit CMOS...
PCF8574 I/O FR I2c port interface support cascading extended module
The PCF8574 IO Expansion Board features I2C pinheader on one side, and I2C connector on the opposite side. Hence, it’s more flexible to connect the board to your development system. The board...
MCP2515 CAN Module TJA1050 Receiver SPI 51 Single Chip Program Routine Arduino
This is MCP2515 CAN Module TJA1050 Receiver SPI 51 Single Chip Program Routine Arduino with this module, you will find easy to control any CAN Bus device by SPI interface with your...
ENC28J60 Ethernet LAN Network Module
The ENC28J60 Ethernet Module(10 Pin Package: SSOP) is a board which contains an Ethernet port and converts Ethernet input into SPI. The board is based on Microchip’s ENC28J60 integrated circuit and it can...
CH375B U-DISK read write module USB interface communication spi interface
The CH375B U Disk Read Write Module is fully compatible with CH372, CH375. The CH375 firmware has a built in dedicated protocol processing Mass-Storage and can be directly used as the basic unit of...