Brushless Motor Controller DC 12V-36V 500W 15A Hall BLDC Motor Balanced Car Driver Board

Brushless Motor Controller DC 12V-36V 500W 15A Hall BLDC Motor Balanced Car Driver Board
1. The motor speed control wiring methods: available potentiometer system speed can also be connected to the MCU control, when the potentiometer control wiring, the potentiometer middle pin is connected to VR speed port, potentiometer connected to both ends of 5V and GND terminal voltage more high speed faster.
2. Motor steering control wiring methods: you can switch control can also be connected to the MCU control, to GND in one direction, then in one direction 5V.

Tips:

 If you use less than 60W, without additional heat sink , be sure to add more than 60W
We recommend cooling surface area greater than 200 square centimeters. Proposes to add insulation films, both sides of the insulating sheet plus thermal grease!

Specification :-

• Operating voltage: DC 12V-36V
  
• Operating Current: Less than 15A
  
• Driver Power: Less than 500W
  
• Speed Voltage: 0.1V-5V
  
• Operating Temperature:-40-85 deg C
  
• Humidity: 90%RH
  
• Stall protection:Yes
  
• Enable Control: Yes
  
• Over-current protection: Yes
  
• Steering control: Yes
  
• Speed control signal: Yes
  
• Probe size 3mm, 
  
• length: fixing hole center distance 57mm. 
  
• width:fixed hole center distance 36.5mm

Product Includes:-

 1 X 12-36V 500W Brushless Motor Controller