DC 4V-6V 5V 2-Phase 4-Wire Stepper Motor Driver Controller Board Mini Stepping Motor Adjustable Speed Regulator with Remote Control CW CCW Drive Module

Description:- 

DC 4V-6V 5V 2-Phase 4-Wire Stepper Motor Driver Controller Board Mini Stepping Motor Adjustable Speed Regulator with Remote Control CW CCW Drive Module

Working Mode:

Normal Mode

• S1 start stop button, S2 forward and reverse button, W2 potentiometer speed button.
• If limit reversal is required, two limit switches can be connected to the P3 pin, and the motor motion shaft is mounted with contacts, so that the motor will reciprocate within the stroke between the two limit switches.

Normal Mode 2:

• S1 forwards the start button, S2 reverses the start button, press any button to stop. W2 potentiometer speed regulation.
• If the limit stop is required, two limit switches can be connected to the P3 pin, so that the motor will stop moving when it touches the limit switch, and the motor will reverse after the opposite button is clicked.

Jog Mode:

• S1 presses the forward rotation, releases the stop, S2 presses the reverse rotation, releases the stop, and the W2 potentiometer adjusts the speed.
• If a limit stop is required, the upper limit switch can be connected to P3.

Automatic Round-trip Mode:

• S1 starts and stops, S2 is reversed, W2 potentiometer speeds, and W1 potentiometer adjusts the automatic round-trip steps.
• After starting, the motor automatically runs back and forth within the number of steps adjusted by W1.

Note:

If you want to change any function pins of P1, P2, P4, you need to cut off the on-board power supply and re-power on the selected function to take effect.

When the load current exceeds 800mA, the circuit is protected, and the running indicator flashes once every 2 seconds. At this time, it is necessary to reduce the working voltage or replace the motor to work normally.

Features:

Multifunction:

• This driver board has 4 working modes: Normal Mode 1 / Normal Mode 2 /Jog Mode / Automatic Round-trip Mode.

Driver Specs:

• Voltage Range: DC 5V-12V; Rated Current: less than 800mA; Board Size: 60x44x16mm/ 2.36x1.73x0.62inch; Button Function: Please refer to the 4th-8th picture remarks.

Fit Motor:

• 2-phase 4-wire and 4-phase 5-wire stepper motor (can drive 3V-24V stepper motor to rotate, the motor torque is different).

Built-in Protection:

• Power Reverse Connection Protection, Over-current Protection, Overheat Protection. Fine workmanship and good performance. Long service life.

Specifications:-

• Voltage Range: DC 5V-12V
• Rated Current: less than 800mA
• Board Size: 2.36*1.73*0.62inch
• Power Reverse Connection Protection: yes
• Over-current Protection: yes
• Overheat Protection: yes
• Key Function: Please refer to the 4th-8th picture

Product Includes:-

1x Driver Board with 10Pin cable