TB6560 CNC 3 Axis Stepper Motor Driver Controller Board For Mach3 KCAM4 EMC2 36V

TB6560 CNC 3 Axis Stepper Motor Driver Controller Board For Mach3 KCAM4 EMC2 36V

Feature:-

1. For toshiba TB6560AHQ chip - High power, maximum 3.5A drive current chipset
2. 1-1/16 microstep setting - Higher accuracy and smoother operation than standard 1, 1/2 step
3. Adjustable drive current settings for each axis - 25%,50%,75%,100% of full current can be set for different stepper motors
4. Overload, over-current and over-temperature safety - Full protection for your computer and peripheral equipment
5· On board current switching - Power output can be set according to specific user requirement
6· Full closed-type optical isolation to protect the user's computer and equipment
7· Relay spindle interface - Outputs Max. 36V 7.5A for spindle motors or coolant pump (only one device can be powered by this output!)
8· 4 channel inputs interface- Can be used for XYZ limit and emergency stop
9· Professional design - Two stage signal processing with super anti-jamming
10· Bipolar constant current chopper drive with non-resonant region - Controls motors smoothly through range without creep effect
11· Four control inputs (divided into pairs of knives) - Allows setting of limit and emergency stop
12· Universal architecture - Supports most parallel software MACH3, KCAM4, EMC2 etc!

Attention:

Power supply DC 12-36V (not included)

*Voltage Selection:

• 12-16V DC power supply for Nema 17 stepper motors
  
• 16-24V DC power supply for Nema 23 stepper motors
  
• 24-36V DC power supply for Nema 34 stepper motors
  (High voltage will burn up the chips or stepper motors!!!)
  

*Ampertage Selection:

• Output current of the power supply can be calculated by the following expressions:
  
• Output current = Rated current of your stepper motors * quantity + 2A
  (For example, if you want to drive 3 * 3A Nema 23 stepper motors, theoretically
• 24V 11A DC power supply is recommended, but higher power such as 24V 15A also will be good.
  
• If you are not sure about the selection of power supply, please feel free to contact us for help)
  
• The power output of 12V shall be applied to the radiator fan of 12V Driver output compatible with 2 or 4 phase, 4,6 or 8 lead stepper motors, 3A max.
  
• Suitable for unipolar or bipolar stepper motors.
  
• Voltage regulated spindle speed controlled by parallel interface as function of supply voltage.

Simple solutions if the driver does not work properly:

• Please double check the software settings according to the Fig.5 and Fig.6
  
• Please conform the parallel cable has been pluged tightly
  
• Please turn off the power supply before changing dip settings
  
• Please use stable high quality DC power supply for this driver
  
• Problems in Mach3 using, Please refer to the Mach 3 User Manual

Specifications:

• Electrical properties (ambient temperature Tj = 25 pm)
  
• Input Power
  
• 12 - 36V DC power supply
  
• Stepper motor drive current
  
• 3A (peak value 3.5A)/axis
  
• Drive type
  
• Double-pole constant flow PWM actuation output
  
• Compatible Stepper motors
  
• 2/4 Phase, 4/6/8 leads stepper motors within 3.5A
  

Package included:

1x TB6560 mould
1 x DB25 parallel cable